LD-1 Label Dispenser.

Application Technologies LD-1 Label Dispenser [LD-1]

The LD-1 Label Dispenser is designed for you, the industrial user. Featuring a solid 12 gauge steel epoxy power-coated frame, with other parts made from stainless steel or heavy duty PVC. This combination assures you of years of hard working service. Fully electronic motor control and non-contact, self adjusting optical label sensor. No finicky sensitivity control adjustments. Just position the sensor where you want the label to stop and go! Convenient Jog function to make setup quick and easy. Sensible straight forward design for ease of operation and excellent ergonomics. Anyone can learn to operate LD-1 Label Dispensers in just a few minutes.

Think about it, if you are placing labels by hand, 30 to 50 percent of the time is used in removing the label from the paper carrier. The LD-1 will pay for itself in a very short time, often in weeks.You just can't afford not to use the LD-1!

Specifications:

Butt-cut or die-cut matrix removed P.S. labels.
Label size 3/4 x 3/4 inches minimum to 6 inches wide by any lenght long. *
Roll Size up to 12 inches in diameter x 6 inches wide wound on standard 3 inch diameter cores.
Dimensions, 13.5 x 12 x 8.5 inches (L x W x H without).
Weight, 16 lbs (7.5 kg).
105-125 VAC 50-60 Hz @ 4 amps.**

*Contact us to discuss smaller sizes.
** 210-240 VAC 50-60 Hz @ 2 amps single phase available upon request.

Label Dispenser Main Page